７９
Type
Configure type of Network (Ethernet/xDSL). If connected to cable modem or Lan directly to DVR,
configure by “Ethernet”.
If DVR connects to xDSL- one of PPPoE type, configure xDSL. But if it is not type of PPPoE,
configure ‘Etherent’.
DHCP
With DHCP (Dynamic Host Configuration Protocol), all hosts connected to Lan can get Public IP
address temporary.
If LAN has DHCP server and it is active, DHCP server allocate IP address to DVR.
Mostly middle and large network use DHCP server in LAN, but in case of small network,
NAT(Network Address Translation) of HUB is general.
IP Addr
IP Address is for the connection between DVR and Control Center and also for web
connectionfrom Webviewer. (But, Net Mask, Gateway should be configured.)
Net Mask
Net Mask makes range of IP address available. It should be received from network
administrator.
Gateway
Gateway is necessary to communicate IP, it should be received from network administrator.
DNS1
DNS1 is mandatory item to regist and use SWR and it should be asked to network administrator.
Additional DNS
Additional DNS is alternative when DNS1 has a problem.
Port
Port is necessary for Control Center and Webviewer connection.
Reference : Basic port is 80 and if using PPPoE modem and AP, be careful typing port
number.
To Next Page
Loading...