41243637000/00/02.17
Printing Operation
6 Printing Operation
NOTE
Printhead damage caused by improper
handling!
Do not touch the underside of the
objects.
Ensure that the labels are clean.
The printer is ready for operation when all connec-
tions have been made and labels and the transfer
ribbon have been loaded.
6.1 Printing in
6.2 Printing in Cutting Mode
The printer version with cutter or perforation cutter is
-
rial automatically after printing.
The cutting mode must be activated in the
software.
With direct programming it is controlled
Instructions.
NOTE
Functional impairment due to dirt!
When using label material, do not cut
through the labels.
6.3 Synchronizing the Paper
Feed
After the label stock has been inserted, for cut-
ting mode a synchronization of the paper feed is
by the label sensor, will be transported to the print
position and all labels in front will be fed out of the
cut label would be too long. That can cause useless
Press to start the synchronization.
Remove the blank labels cut during the synchro-
nization
Synchronization is not necessary if the
printhead was not opened between dif-
ferent print jobs, even if the printer was
To Next Page
Loading...
Need help?
General
