Weiler E1650 - Engine Oil Check; Engine Stop Buttons Test

1
WEILER E1650 REMIXING TRANSFER VEHICLE
5-26
Maintenance
5
Maintenance Procedures
Engine Oil - Check
With engine level, fill to full mark on dipstick. Do not
overfill.
1. To check oil level, stop engine and allow engine oil
to settle for 5 minutes.
2. Check oil level with dipstick (1).
NOTICE: Maintain oil level on dipstick between “Full”
and “Add” marks. Do not overfill crankcase. Oil level
must not be above full range on dipstick.
3. Clean oil filler cap (2) and surrounding area before
removing cap. Add oil if necessary.
4. Install oil filler cap (2).
Engine Stop Buttons - Test
1. Press red Engine Stop Button (1) while engine is
running. Engine must stop.
2. With Engine Stop Button depressed, try starting
engine. Engine will crank but must not start.
3. Repeat Engine Stop Button check for each stop
button.
4. Contact a Weiler dealer if an Engine Stop Button
does not function correctly.
1
2
1