WEILER E1650 REMIXING TRANSFER VEHICLE
5-41
Maintenance
5
Maintenance Procedures
Pump Drive Gearbox Oil - Check
1. Allow pump drive gearbox oil to settle for 5 minutes
after shutting off engine.
2. Check oil level with dipstick (1).
NOTICE: Do not overfill.
3. Maintain oil level on dipstick between “Full” and
“Add” marks.
4. Clean area around pump drive breather/fill
fitting (2).
5. Remove breather/fill fitting and add oil if
necessary.
6. Install breather/fill fitting.
Safety Signs - Check / Clean
To ensure that all safety signs remain in place and in good condition:
•Keep safety signs clean. Use soap and water - not mineral spirits, abrasive cleaners, or other
similar cleaners that will damage the sign.
•Replace any damaged or missing safety signs. When attaching new safety signs, the temperature
of the mounting surface must be at least 40°F (5°C). The mounting surface must be clean and
dry.
•When replacing a machine component with a safety sign attached, replace the safety sign also.
• Replacement safety signs can be purchased from your Weiler dealer.
To Next Page
Loading...
