102 EN LIFE-BASE
WM 68331 04/2021
6 Operation
6.3.7 Fastening the wall mounting with retaining
claws
Applies to • BASE-STATION 1 NG without screws
• BASE-STATION Mini II
• BASE-STATION 3 NG
Requirement The retaining claws are attached to the wall mounting.
1. Suspend the wall mounting on the equipment rail using
the retaining claws.
2. Warning! Risk of injury due to inadequate fastening
of the portable unit!
Push the locking levers outwards until the locking mechanism
noticeably engages.
When doing so, note: The locking levers must be parallel to
the equipment rail.
3. With BASE-STATION Mini II and BASE-STATION 3 NG:
Tighten the screws.
Result The wall mounting is fastened to an equipment rail with
retaining claws.
To Next Page
Loading...
Need help?
General
