Operation
0570−1/A1
Winterthur Gas & Diesel Ltd.
1/ 1
Defective Speed Control System
1. General
Defects in the speed control system must be repaired as soon as possible (see the
documentation of the manufacturer). If this is not possible, you can control the engine
from the local control panel.
If the fuel command signal from the speed control system is missing during engine
operation, the speed control system will continue to operate. The last known fuel
command will be used and you will hear an alarm.
The data are given in the groups that follow:
D 0230−1 Starting
D 0260−1 Maneuvering
D 0310−1 Engine Shutdown
D 0320−1 Procedures after Engine Stop
D 4003−1 Engine Control, paragraph 3
D 4618−1 Local Control Panel.
CAUTION
Damage Hazard: You must only operate the engine during
unusual conditions when necessary. You must not leave the
maneuvering stand. You must monitor the engine speed
frequently to make sure that procedures are immediately done if
large differences in engine speed occur.
2014
Operation during Unusual Conditions
To Next Page
Loading...
Need help?
General
