Operation0230−1/A1
Winterthur Gas & Diesel Ltd.
2/ 2
3.2 Engine Start Procedure
1) Push the button AUX. BLOWER PRESEL.
2) Push the button FUEL CONTROL MODE.
3) Turn the rotary knob to set the fuel injection quantity to approximately 15%.
4) Push the button START AHEAD or START ASTERN until the engine operates.
5) Slowly turn rotary knob to adjust the fuel injection quantity until the engine
operates at the necessary speed. You can see the related value on the display
and speed indicator.
6) Read the instructions for speed/power increase (see Maneuvering 0260−1) and
monitor the data (see Operating Data Sheet 0250−1).
You can also do the engine start procedure above from the ECR manual control
panel.
Note: You can use the buttons and rotary button only at the related active control
stand (see 4618−1 WECS−9520 manual control panel).
Engine Start
2014
To Next Page
Loading...
