32 Instructions for use
EN
Make sure that the gap between the clamp and the stem is the same at the top and bottom.
5�2�2 Setting the brake lever position and reach
Your woom bike arrives with a preset distance between
the handlebar grip and the brake lever. To reduce the
distance between the brake lever and the handlebar grip,
turn the brake lever adjustment screw (1) anti-clockwise.
To increase the distance, turn the screw clockwise. Turn
the screw just far enough to ensure that the brake lever
can never touch the handlebar grip, even when applied
under serious force. Never completely unscrew it from
the brake lever. To adjust the position of the brake lever
on the handlebars, loosen the clamp bolt (2) by turning
it anti-clockwise and reposition the lever. Finish up by
tightening the clamp bolt to the required torque (see
chapter 8). Make sure that your child is comfortably able
to reach and operate the brake levers.
Brake lever adjustment screw and clamp bolt
5�2�3 Adjusting the trigger shifter reach
Your woom bike comes with the trigger shifter in a
standardized position. To change the position (and the
distance to the trigger shifter), loosen its clamp bolt
using a 5 mm hex key and reposition as necessary to suit
the rider. When in position, retighten the clamp bolt to
the required torque (see chapter 8). Make sure that your
child is comfortably able to reach and operate the trigger
shifter.
Trigger shifter clamp bolt
5�2�4 Setting up the MTB grips
While making adjustments, make sure that the grips are pushed inwards onto the handlebars as far as they will go
before tightening the clamp bolts.
To Next Page
Loading...
