Instructions for use 33
EN
When your child is holding the grips in a normal riding position,
their wrists should be slightly bent.
We recommend positioning the grips so
that the clamp bolts face forward and the
woom logo on the clamps faces upwards.
To adjust, use a 3 mm hex key to loosen the clamp bolt on the
inner edge of the grips.
Turn the grip into the desired position before tightening the
clamp bolt to the required torque (see chapter 8).
5�2�5 Installing the front wheel
When installing the front wheel, make sure that the spacer sleeves are mounted on both sides of the hub.
woom OFF: Remove the thru-axle from
the fork. Remove the safety spacers
from the brake calipers and store them
somewhere safe in case you travel with
the bike in future.
After removing the spacers, do not
operate the front brake lever
without the disc brake rotor in place
as this will lock up the brake pads.
woom OFF AIR: Open the quick-release
lever and remove the thru-axle from the
fork. Remove the safety spacers from the
brake calipers and store them somewhere
safe in case you travel with the bike in
future. After removing the spacers,
do not operate the front brake lever
without the disc brake rotor in place
as this will lock up the brake pads.
Remove the protective plastic disc from
the disc brake rotor. Make sure that
the black distance spacer remains on
the hub. This can sometimes get stuck
on the protective plastic disc. If this
happens, pull it o and simply insert it
back into the hub.
To Next Page
Loading...
