36 Instructions for use
EN
5�2�8 Setting up the suspension fork (woom OFF AIR)
Setting the correct air pressure in the fork
The woom OFF AIR comes with a preset air pressure.
If you want to change this, you will need a shock pump.
Here’s what to do:
©
First, unscrew the valve cap (see picture) on the
upper left of the fork by turning it anti-clockwise.
©
Use the table below to determine how much air
the fork needs for the rider’s weight.
© Replace and tighten the valve cap.
20” 24 and 26”
Rider’s weight [kg] Air pressure [psi]* Rider’s weight [kg] Air pressure [psi]*
<20 20–25 20–30 40–50
20–25
25–30
30–45
50–65
25–30
30–35
45–65
65–85
30–35
35–40
>65
85–100
* Max. permissible air pressure: 150 psi
Setting the rebound damping
The rebound damping and rebound speed of the air
suspension fork can be adjusted with the red dial on the
lower right end of the fork.
© Turn the red dial in the - direction to increase the
rebound speed and reduce the rebound damping.
©
Turn the dial in the + direction to reduce the re-
bound speed and increase the rebound damping.
Setting the compression damping
The compression damping and compression speed of the
air suspension fork can be adjusted with the adjustment
dial on the upper right end of the fork.
© Turn the adjustment dial clockwise to increase the
compression speed and reduce the compression
damping.
© Turn the adjustment dial anti-clockwise to reduce
the compression speed and increase the com-
pression damping.
Lockout function
To activate the lockout function (which turns the suspension fork into a rigid fork), turn the compression damping
adjustment lever anti-clockwise as far as it will go. Do this on uphills and at, smooth stretches where you don’t
need suspension.
To Next Page
Loading...
