Safety
16
2.1 Authorized use
This measuring system is authorized exclusively for
potentiometric, conductimetric or amperometric
measurements in the laboratory.
The technical specifications as given in chapter 15
T
ECHNICAL DATA must be observed. Only the operation and
running of the measuring instrument according to the
instructions given in this operating manual is authorized.
Any other use is considered unauthorized.
2.2 General safety instructions
This measuring system is constructed and tested in
compliance with the EN 61010-1 safety regulations for
electronic measuring instruments.
It left the factory in a safe and secure technical condition.
Function and
operating safety
The smooth functioning and operational safety of the
measuring system can only be guaranteed if the generally
applicable safety measures and the specific safety
instructions in this operating manual are followed during
operation.
The smooth functioning and operational safety of the
instrument can only be guaranteed under the environmental
and electrical operating conditions that are in specified in
chapter 15 T
ECHNICAL DATA.
If the measuring system was transported from a cold
environment to a warm environment, the formation of
condensate can impair the functioning of the measuring
system. In this event, wait until the temperature of the
measuring system reaches room temperature before putting
the measuring system back into operation.
Warning
The measuring system is only allowed to be opened by
personnel authorized by WTW.
To Next Page
