wtw inoLab Level 3 - 4 Basic Principles of Operation

Basic principles of operation
33
4 Basic principles of operation
This section provides basic information on the operation of
the measuring system and the display of the measured
values.
The terminal has two operating modes:
l Display mode
The display shows the current measured value.
Change to the Menu mode using the [menu] softkey.
l Menu mode
The display shows open menus and submenus. For
example, you can operate or set up the following
functions here:
- measuring functions
- calibration functions
- memory functions
- printer/interface functions
- general and system settings
Return to the Display mode by pressing
m or by pressing
the [ESC] softkey several times.
The inoLab Level 3 measuring system is operated via the
terminal. The AutoRead function and starting a
measurement with AutoRead can also be operated from the
measuring module.