wtw inoLab Level 3 - 7 Ion Concentration; Settings for ISE; Displaying Ph;Ise or Measured Voltage Values; Setting up the ISE Display

Ion concentration
93
7 Ion concentration
For the inoLab Level 3 measuring modules:
pH, pH/ION, pH/Cond, pH/Oxi and Multi.
7.1 Settings for ISE
We recommend checking the current settings and correcting
them if necessary before a measurement.
7.1.1 Displaying pH/ISE or measured voltage values
In pH/ISE measurements, inoLab Level 3 enables a rapid
changeover between the display of the pH/ISE value (pH)
and voltage (U).
7.1.2 Setting up the ISE display
Ion-selective electrodes are connected to the pH/U
connector of the measuring module.
The selection of the measured variable ISE or pH is made in
the main Meas menu. The active pH or ISE setting is marked
with ✔.
Measured variable,
ISE
1 Activate the Display mode.
2 Switch to the display of the pH/ISE value with
m.
3 Switch between the measured value display of the
pH/ISE value (pH) and voltage (U) with
46.
1 Switch to the Menu mode.
2 Use
46 to select the main Meas menu.
3 Select the ISE menu item with 82.