wtw inoLab Level 3 - Settings

Commissioning
28
3.4 Settings
To obtain the best results and to make use of the entire
range of functions of the inoLab Level 3 measuring system,
the measuring system must be configured and calibrated.
You can adapt the configuration to your measuring
environment and your requirements via system settings and
probe-dependent settings.
System settings The system settings include the following settings:
l Date and time (chapter 5 SYSTEM SETTINGS)
l Display options (chapter 5 SYSTEM SETTINGS)
l Language selection(chapter 5 SYSTEM SETTINGS)
l Data storage settings (chapter 11 DATA STORAGE)
l Printer settings (chapter 12 DATA OUTPUT)
l Temperature unit (section 5.5.1 TEMPERATURE UNIT)
Probe-dependent
settings
Probe-dependent settings include, e.g.:
l Selection of the measuring range
l Selection of the display of various measured variables
More detailed information is given in the descriptions of the
individual measured quantities in the section S
ETTINGS
(chapter 6 to chapter 10).
Calibration More detailed information is given in the descriptions of the
individual measured quantities in the section C
ALIBRATION
(chapter 6 to chapter 10).