wtw inoLab Level 3 - 6 Ph; Settings for Ph; Displaying Ph;Ise or Measured Voltage Values

pH
71
6pH
Measuring modules for the inoLab Level 3:
pH, pH/ION, pH/Cond, pH/Oxi and Multi.
6.1 Settings for pH
We recommend checking the current settings and correcting
them if necessary before a measurement.
6.1.1 Displaying pH/ISE or measured voltage values
For pH measurements, the inoLab Level 3 enables rapid
switching between the display of the pH value (pH) and the
voltage (U).
1 Activate the Display mode.
2 Switch to the display of the pH value with
m.
3 Switch between the measured value display of the
pH value (pH) and voltage (U) with
46.