103
XAG AUSTRALIA
Turning On the Aircraft:
01. Initiate by inserting the battery into the aircraft's battery compartment. Again, gently push
downward until a clicking sound is heard, indicating that the battery terminal is now connected
to the aircraft.
02. Proceed by pressing and holding the power button on the battery for about 1 second. Upon
doing this, all indicator lights should flash. Press and hold the power button once more for
around 1 second until a beep from the battery is heard.
03. After completing these steps, kindly wait until the Aircraft Flight Status (ESC) Indicator flashes
green three times. This sequence of flashes signals that the aircraft is now ready for use.
Turning Off the Aircraft:
01. Begin by pressing and holding the power button on the battery once for approximately 1 second
until all the indicator lights flash. Following this, press and hold the power button once more for
about 1 second until a beep from the battery is heard.
02. At this point, both the Battery Indicator and Aircraft Flight Status (ESC) Indicator will switch off,
signalling that the battery can now be safely removed or replaced as necessary.
Turning the Aircraft ON/OFF
To Next Page
Loading...
