XAG P100 Pro - Operation Parameters - Route Settings

XAG AUSTRALIA
148
APPROACHING ROUTE
- Enable Guide point Planning Allows the use of guide points to plan the approach route,
providing precise navigation and alignment.
- Flight Height Specifies the altitude at which the equipment will fly during the
approach, ensuring proper positioning for the operation.
- Flight Speed Determines the speed at which the equipment will approach the
operation area, allowing for controlled and timely arrival.
Operation Parameters – Route Settings
OPERATION ROUTE
- Flight Height Sets the altitude for the main operation, directly affecting the
spray or spread width. A higher flight height may result in a wider
spray or spread pattern, while a lower height may concentrate
the application. This parameter allows for precise control over
the application of materials, ensuring optimal coverage and
efficiency.
- Flight Speed Controls the speed during the main operation, balancing
efficiency, and accuracy.
- Route Direction Defines the direction of travel along the operation route, ensuring
proper alignment with the target area.
- Route Spacing Specifies the distance between parallel passes, allowing for
uniform coverage or application.
- Boundary Safety clearance Sets a safety buffer around the boundaries of the operation area,
preventing accidental intrusion or overspray.
- Obstacle Safety Distance Determines the minimum distance the equipment must maintain
from the marked obstacles, enhancing safety and preventing
collisions.