63
XAG AUSTRALIA
Starting and stopping the motors of your drone properly is crucial for safe take-off and landing. It's
also important to remember to do this in one smooth action. Below is how to perform it:
To start the motors and prepare for take-off, perform the Combination Stick Command (CSC).
01. Move both sticks to the inner-lower corners or outer-lower corners simultaneously. This action
should be performed smoothly and quickly.
02. Once you've completed the CSC, you'll have 3 seconds to push the throttle stick upwards to lift
the drone off the ground. If you don't do this within the 3 seconds, the motors will automatically
shut down.
or
Throttle Stickleft
(Left stick in Mode 2)
Take-off / Landing
Take-off / Starting Motors
Starting Motor
Take-off
Please remember, failure to lift off promptly after completing the CSC could cause the drone to lose
balance, move sideways, or even lift off on its own, which could lead to damage or injury. Therefore,
always be prepared to push the throttle stick upwards immediately after completing the CSC.
ℹ
IMPORTANT
To Next Page
Loading...
