EasyManua.ls Logo

XAG P100 Pro - Battery Charging

XAG P100 Pro
184 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71
XAG AUSTRALIA
Battery Charging
ENSURE there are no obvious defects on the Battery or the Charger before use.
ENSURE there are no liquid or foreign matter on the battery terminal, wipe and clean in a timely
fashion. Otherwise, it may cause poor contact, resulting in loss of power or charging failure.
ENSURE Batteries & Chargers is placed on even ground with no nearby combustible materials.
ENSURE Batteries have a minimum of 30cm distance between the batteries and Chargers
during Charging.
ENSURE the Batteries are recharge every 90 days to maintain battery health.
ENSURE pure water is used for heat Dissipation.
ENSURE Water level should be kept between the Minimum and Maximum Water levels to
achieve the best heat dissipation effect.
DO NOT clean the charging device with alcohol or other combustible liquids.
DO NOT disconnect the AC cable or the Charging cable while the Charger is in use.
DO NOT use this product under direct sunlight, in rain, or in a humid environment.
DO NOT exceed the Max. Water level or Submerge the Battery in Water, or Battery will be
damage.
DO NOT use Corrosive liquids for heat Dissipation, or Battery will be damage.
DO NOT exceed 60 minutes for heat Dissipation, or Battery will be damage.
DO NOT store Batteries with less than 30% Power or for an extended period, otherwise it may
damage the battery or impact battery life.
IMPORTANT
15A Socket

Table of Contents

Other manuals for XAG P100 Pro

Related product manuals