147
XAG AUSTRALIA
Spreading Settings (with RevoCast P3)
Granule Type Specifies the type of granular material being spread, allowing the
system to optimize the RevoCast System.
Spreading Rate Controls the amount of granular material spread per unit area. It
can be adjusted to meet specific application needs.
Spread during lane Change
-
Enable Seeding on both sides
Allows spreading on both sides of the equipment during a
lane change, ensuring uniform distribution.
-
Turn OFF
Stops spreading during a lane change to prevent over-
application.
Advance Settings
- Enable Fly Only When activated, this function allows the equipment to only fly
without conducting any spraying. It's useful for navigation or
repositioning without applying any materials.
- Low Volume RTL & Auto Drain
Mode
Triggers Return to Land (RTL) mode when liquid levels are low
and automatically drains the remaining liquid.
- Freed Spreading Mode When enabled, this mode allows the maximum route spacing
for spreading to be 100 meters. It provides greater flexibility in
the application of granular material, accommodating larger
distances between passes and potentially increasing efficiency in
certain scenarios.
To Next Page
Loading...
