XAG AUSTRALIA
162
Cleaning Procedure - RevoCast System
To prevent complications such as material accumulation and clogging, the RevoCast system should
be cleaned after each day's spreading operation. This practice ensures the spreading efficiency of
the RevoCast system. Follow these steps for a comprehensive cleaning:
①
②
Spreading Disc Mark
02
01
01. Disconnect the Spreader Motor Cable.
02. Open the hasps of both Quick-release unit.
03. Extract the quick-release units and rinse the Spiral Feeders and the cross slots at the base of
the Spiral Feeders. After rinsing, ascertain there are no foreign objects remaining in the Quick-
release unit, then place them in a cool, shaded area to dry.
04. Open the Material covers on both side and rinse the residual materials in the material container
with clean water. After rinsing, place it in a cool, shaded area to dry.
05. Once the quick-release units and the material container are dry, reinstall the left and right
quick-release units in their original positions. Perform a manual spreading test before the next
spreading operation to ensure that the RevoCast system is functioning properly.
To Next Page
Loading...
