5. To permit the staple cartridge handle to open out and away from the staple refill,
press in the green tabs, then pull back the handle.
6. To remove the staple refill, press the rear of the refill container as shown.
7. Replace the staple refill, then return the staple cartridge to the booklet maker.
Emptying the Hole Punch Waste Container
A message appears on the Control Panel when the hole punch waste container is full.
Warning
Do not perform this procedure while the printer is copying or printing.
To empty the hole punch waste container:
1. Open the front door of the Business Ready finisher.
2. Remove the hole punch waste container from its slot near the top left of the finisher.
• Wait 10 seconds before reinserting the container into the printer. The hole punch
counter resets after 10 seconds.
12-5Xerox
®
Color C60/C70 Printer
User Guide
Business Ready Finisher and Booklet Maker
To Next Page
Loading...
