8. Close the Front Door. If the door will not close completely, make sure the cartridge
is in the lock position and the toner cartridge is installed into the appropriate toner
location.
Caution
Never use a vacuum cleaner when you clean spilled toner. It can cause explosion as the
toner fills the vacuum cleaner and gets sparks. Use a broom or a cloth moistened with
a neutral detergent.
Replacing the Fuser
This procedure shows you how to remove a used Fuser and replace it with a new Fuser.
The machine will tell you when you need to install a new one. The Fuser can be recycled
so please follow the disposal instructions you receive with the new cartridge.
1. Make sure the machine has stopped running, and open the Front Door.
2. Grasp Handle #2 and turn it to the unlocked position.
Warning
To avoid burns wait at least 5-10 minutes after powering off the printer to allow
the fuser to cool down, and observe warning labels inside.
3. Carefully pull out the Transfer Module.
9-7Xerox
®
Color C60/C70 Printer
User Guide
Maintenance
To Next Page
Loading...
Need help?
General
