Xerox WorkCentre 6027

Copying
148 Xerox
®
WorkCentre
®
6027 Multifunction Printer
User Guide
Changing the Default Color Balance
The Color Balance control allows you to adjust the print color of your printer. Each of the four primary
colors of red, green, blue, and gray balance, have five density settings. The density settings adjust the
output based on the level of color saturation. Adjusting the setting negatively lowers the density and
lightens the output. Adjusting the setting positively increases the density and darkens the output.
Examples of low density areas include faces and sky.
To change the default color balance:
1. Touch Color Balance.
2. Touch the color you want to adjust.
3. To adjust the default density setting from -3 through +3, touch - or +.
4. Touch OK.
Changing the Default for 2-Up
1. Touch 2-Up, then select an option.
2. Touch OK.
Changing Edge Erase
1. Touch Edge Erase.
2. To set the edge erase default, touch the + or - buttons.
3. Touch OK.