Xilinx Virtex UltraScale+ FPGAs

Table 74: GTM Transceiver PCB Design Checklist (cont'd)
Pins Recommendations
MGTAVCC[N]
1
• For UltraScale+ FPGAs, the nominal voltage is 0.9 VDC.
• See the UltraScale+ device data sheets (see http://www.xilinx.com/documentation) for power
supply voltage tolerances.
• The power supply regulator for this voltage should not be shared with non-transceiver loads.
• Many packages have multiple groups of power supply connections in the package for
MGTAVCC. Information on pin locations for each package can be found in the UltraScale and
UltraScale+ FPGAs Packaging and Pinouts Product Specification (UG575).
• The following filter capacitor is recommended:
○ 1 of 4.7 μF ± 10% per power supply group (see Figure 48: UltraScale+ Device Transceiver
Power Supply Groups and RCAL Master)
• For optimal performance, power supply noise must be less than 10 mVpp.
• If all of the Duals in a power supply group are not used, the associated power pins can be left
unconnected or tied to GND.
• For power consumption, refer to the Xilinx Power Estimator (XPE) at www.xilinx.com/power.
MGTMAVTT[N]
1
• For UltraScale+ FPGAs, the nominal voltage is 1.2 VDC.
• See the UltraScale+ device data sheets (see http://www.xilinx.com/documentation) for power
supply voltage tolerances.
• The power supply regulator for this voltage should not be shared with non-transceiver loads.
• Many packages have multiple groups of power supply connections in the package for
MGTAVTT. Information on pin locations for each package can be found in the UltraScale and
UltraScale+ FPGAs Packaging and Pinouts Product Specification (UG575).
• The following filter capacitor is recommended:
○ 1 of 4.7 μF ± 10% per power supply group (see Figure 48: UltraScale+ Device Transceiver
Power Supply Groups and RCAL Master)
• For optimal performance, power supply noise must be less than 10 mVpp.
• If all of the Duals in a power supply group are not used, the associated power pins can be left
unconnected or tied to GND.
• For power consumption, refer to the Xilinx Power Estimator (XPE) at www.xilinx.com/power.
Chapter 5: Board Design Guidelines
UG581 (v1.0) January 4, 2019 www.xilinx.com
Virtex UltraScale+ GTM Transceivers 131
Send Feedback