1. Notice to XPENG Owners
14
Scheduled ChargeScheduled Charge
This function allows the vehicle to start charging at a specified
time and to automatically stop charging when the battery is
fully charged (or reaches the limit).
Schedule charge as the following steps:
1. Click the icon in the CID status bar to enter the
“Charging Function” panel.
2. Click the “Schedule Charge” switch button to enter the
“Schedule Charge” panel.
3. Set the scheduled charging time (with 1 min as the
minimum unit).
4. Open the charging port lid. Refer to Page 11.
5. Take the charging gun o the AC charging pile and plug it
into the AC charging port vertically to enter the scheduled
charging.
6. Observe the charging indicator lights. Refer to Page 10.
Note
●
The charging may be prolonged due to factors such as
environment temperature and traction battery life.
●
Under some special operating conditions (for example,
the gun is still plugged for a long time after charging
is completed), the automatic closing function of
the charging port lid while unplugging gun will be
temporarily deactivated in order to save power. Please
close the charging port lid in time to avoid rain, snow
or other foreign objects from entering.
●
When charging at a low environment temperature,
the system will heat the traction battery first, and
then charge it when its temperature becomes normal.
So the charging will take a slightly longer time than
normal.
●
When the indicator shows an abnormal charging
warning, you can try to repeat the charging steps,
restart the whole vehicle, or use another charging
pile. Do not repeatedly plug and unplug the charging
gun and manipulate the charging pile operation
interface. If the abnormal charging warning still exists,
please contact your local authorized service center for
troubleshooting.
●
During AC charging, the power of the air conditioner is
preferentially allocated to the battery heating, which
may cause the air conditioner not to be cooled or
heated.
https://www.automotive-manuals.net
To Next Page
Loading...
