Introduction and Safety Page: 4 Introduction Purpose of this manual: provide necessary information for installation, operation, and maintenance.
Qualified Personnel Specifies that the product is intended for operation by qualified personnel only.
Safety Details safety precautions to prevent physical injury and equipment damage.
User Safety General safety rules including work area cleanliness and electrical danger avoidance.
Warranty Information about warranty terms, refer to sales contract.
Spare Parts Warning to use only original spare parts to prevent malfunctions and damage.
Product Description Page: 12 Applications Lists application alternatives for the product, including Actuator, Controller, and Cascade modes.
Actuator Mode for single pump operation controlled by external speed signal or programmed frequencies.
Controller Default operating mode for single pump operation.
Cascade Relay One pump controlled by the unit, up to five slave pumps switched on/off on demand.
The Data Plate Explains the type definition code and its placement on the data plate.
Technical Data Provides electrical specifications, environmental specifications, and installation data.
Optional Components Describes optional components like motor cables, mounting rings, and various cards.
Electrical Installation Page: 26 Precautions General warnings and precautions for electrical connections, including hazard awareness.
Protection Devices Information on recommended fuses and circuit breakers for short-circuit and over-current protection.
Wire Type and Ratings Recommendations for power connection cables, wire cross-sections, and tightening torques.
EMC Compatibility Requirements for electromagnetic compatibility, including cable shielding and installation.
EMC Requirements Details Hydrovar's compliance with EN61800-3 categories and motor cable length classification.
Wiring the Cables Ensuring electromagnetic compatibility through proper cable installation and grounding.
RFI Switch Procedure for deactivating the RFI filter when the mains power supply is impedance-grounded.
Motor Connection Guidance on connecting motor wiring, including phase connections and grounding.
Control Terminals Information on wiring control terminals and the wiring harness scheme.
RS485 Connection Connecting for communication in multi-pump applications and with external devices.
Status Relays Using terminals to make available status relay contacts for pump status indication.
Relays (X4) Connecting up to 5 fixed speed pumps through an external panel via terminals X4/1 to X4/6.
Programming Page: 43 Software Parameters Organizes software parameters into two groups: menu definitions and configuration parameters.
M00 Main Menu Scope of the main menu, including Home, value selection, language, and auto-start settings.
M20 Status Submenu to check the status of connected units, including failures and motor hours.
M40 Diagnostics Provides parameters for checking production date, temperature, current, voltage, frequency, and software version.
M60 Settings Includes parameters for password, JOG mode, display contrast, and brightness.
M100 Basic Settings Configuration of operation mode, pump address, password, lock function, and display settings.
M200 Conf.Inverter Settings for software, number of units, ramp settings, motor settings, and STC protection.
M300 Regulation Parameters for Jog, Window, Hysteresis, Regulation mode, and Lift settings.
M400 Sensor Configuration for actual-value sensors, including dimension unit, type, range, curve, and calibration.
M500 Sequence Contr. Parameters for configuring multi-pump systems, including actual value, frequency, and delay settings.
M600 Error Parameters for minimum threshold limit, delay time, and automatic error reset.
M700 Outputs Configuration of analog outputs and status relays 1 and 2.
M800 Required Values Configuration of required values, switching between them, and required frequencies for Actuator mode.
M900 Offset Parameters for configuring offset input, range, and level settings.
M1000 Test Run Settings for automatic test run, frequency, boost, time, and manual test run.
M1100 Setup Options for restoring factory settings, setting password 2, and clearing error memory.
M1300 Start-Up Parameters for quick start-up, including language, motor configuration, and required value.
To Next Page
General
