Yaesu FTM-100DR/DE User Manual

104
Functions to Use as Necessary
Functions to Use as Necessary
Copying the radio data to another transceiver
The memory channels and settings in the set-up menu can be copied to another FTM-
100DR/DE transceiver. This is convenient, for example, to configure the transceiver to
match to the settings of stations that you communicate with frequently.
Using a micro-SD memory card
The data files saved in the FTM-100DR/DE can be selected and copied to a micro-SD
memory card which may then be used to transfer the data to other FTM-100DR/DE
transceivers.
Copying data to a micro-SD memory card
1 Insert a micro-SD memory card into the transceiver.
Tip See “Inserting a micro-SD memory card” on page 32.
2 Press and hold for over one second.
The Setup menu appears.
3 Rotate the DIAL to select [11 SD], then press .
The menu list appears.
4 Rotate the DIAL to select [1 BACKUP], then press
.
Displays the screen where you can select the copy
direction.
5 Rotate the DIAL to select [1 Write to SD], then press
.
The screen is displayed where the type of data to be
transferred is selected.
“1 ALL”: Copies all data in the transceiver.
“2 MEMORY”: Copies only information registered to the memory channels.
“3 SETUP”: Copies only settings in the Setup menu.
6 Rotate the DIAL to select the data to be copied, and
then press
.
The confirmation screen appears.

Yaesu FTM-100DR/DE Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Modulation Types	FM, C4FM
Display Type	Color TFT
Memory Channels	1000
GPS	Yes
APRS	Yes
Operating Modes	Simplex, Repeater
Supply Voltage	13.8V DC
Bluetooth	Yes
RF Power Output	50W