85
Convenient Functions
Communicating with specific stations
Using the DCS function
1 Press and hold for over one second.
The Setup menu appears.
2 Rotate the DIAL to select [4 SIGNALING], then press
.
The menu list appears.
3 Rotate the DIAL to select [4 SQL TYPE], then press
.
4 Rotate the DIAL to select [DCS], then press for
over one second.
Tips • Rotating the DIAL changes the squelch type in the
following order:
“OFF”, “TONE ENC”, “TONE SQL”, “REV TONE”,
“DCS”, “PR FREQ”, “PAGER”, “DCS ENC”*, “TONE
DCS”*, “DCS TSQL”*
* To display these squelch types, from the Setup menu,
select [4 SIGNALING] → [9 SQL EXPANSION]
followed by “1 ON”.
• Instead of following the steps 1 to 4 above, the squelch
type may be changed by pressing and holding
for over one second.
Displays on the screen.
The squelch opens only when receiving a signal containing the corresponding DCS
code.
Tip
A bell tone (beep) may be set to sound when signals containing a corresponding DCS code are
received. See “Notification of incoming calls from partner stations using the bell function” on page
89.
To Next Page
Loading...
Need help?
General
