34
Basic Operations
Basic Operations
Receiving
Turning the power on
1
Press and hold for over 2 seconds.
The power switches on, and the display appears on
the screen.
<When using the same call sign for digital and APRS>
<When using separate call signs for digital and APRS>
The call sign for digital appears on the left and the
call sign for APRS appears on the right.
Tips • When turning the transceiver on for the first time, or after resetting the transceiver, a screen
requesting input of a call sign appears.
• When turning the transceiver on thereafter, the previously registered call sign will be
displayed.
Switching the power off
1
Press and hold
for over 2 seconds.
The screen display disappears, and the power switches off.
Inputting the call sign
A screen requesting input of a call sign appears when
turning the transceiver on for the first time, or after
resetting the transceiver.
The call sign is used to identify the transmitting station
when communicating in digital mode.
1 Rotate the DIAL to select characters, then press
.
Tips • Up to 10 characters (alphanumeric characters including
hyphen) can be entered.
• See “Input characters” on page 20 on how to operate
the character input screen.
To Next Page
Loading...
Need help?
General
