49
Basic Operations
Other settings
7 Rotate the DIAL to select the desired contrast level.
The contrast may be selected from the following 7
levels.
“−3”,“−2”,“−1”,“0”,“+1”,“+2”and“+3”
Tip The default setting: 0
8 Press and hold for over one second.
The selected contrast level is set and the display returns to the previous operating
screen.
Tip You can also return to the previous screen by pressing 3 times.
Restoring defaults (All Reset)
All transceiver settings and memory content may be restored to the defaults.
1 Press and hold for over one second.
The Setup menu appears.
2 Rotate the DIAL to select [13 RST/CLONE], then
press
.
The menu list appears.
3 Rotate the DIAL to select [1 FACTORY RESET],
then press
.
4 Rotate the DIAL to select [OK?], then press .
Tip To cancel resetting, select [Cancel].
A beep sounds and the call sign input display
appears on the screen.
5 Input the call sign.
Input the call sign using the numeric key pad. See “Input characters” on page 20
for instruction on inputting the call sign characters.
6 Press .
Sets the call sign and displays the frequency screen.
To Next Page
Loading...
Need help?
General
