66
Scanning
Searching for signals
Specifying memory channels
Specific memory channels to be scanned may be selected using the Setup menu “2
MEMORY SCAN TYPE” set to “2 SELECT MEMORY”.
1 Press and hold for over one second.
The MEMORY WRITE screen appears.
2 Press
,
(
appears on the left side).
3 Rotate the DIAL to select the desired memory
channel.
4 Press twice, ( appears on the upper
side).
On the right side of the memory channel number
display, “►” lights up. This indicates the “SELECT”
state. The memory channels marked with this
indicator are scanned when scanning only specified
channels.
Tips • To unselect the memory channel, press the button again. “►” turns off.
• To specify other memory channels, repeat steps 3 to 4.
5 Press .
The previous screen returns and “►” is displayed on the left side of the memory
channel number.
To Next Page
Loading...
Need help?
General
