Yaesu FTM-100DR/DE User Manual

44
Basic Operations
Communicating
Changing the 100.0 Hz CTCSS tone squelch
Tocommunicatewitharepeaterthatusesatonesignalotherthan100.0Hz,changethe
CTCSS tone frequency using the setup menu.
1 Tune the transceiver receiver frequency to the
repeater frequency.
2 Press for more than one second.
Setup menu appears.
3 Turn the DIAL to select [4 SIGNALING], and then
press
to display the menu list.
4 Turn the DIAL to select [1 TONE SQL FREQ] and
then press
, the CTCSS tone frequency will be
displayed.
5 Turn the DIAL to change and select the different tone
frequency.
6 Press for more than one second to set the new tone and return to the original
operating screen.
Tip You can also return to the previous operating screen by pressing 3 times.
7 Press the [PTT] to transmit.
The transmit frequency is automatically offset to the repeater input frequency, and
the squelch tone signal is set.
Tip
The squelch tone and transmit offset frequency will be recorded whenever the displayed frequency is
registered to a memory channel. (Refer to “Registering to the memory channel” on page 51).

Yaesu FTM-100DR/DE Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Modulation Types	FM, C4FM
Display Type	Color TFT
Memory Channels	1000
GPS	Yes
APRS	Yes
Operating Modes	Simplex, Repeater
Supply Voltage	13.8V DC
Bluetooth	Yes
RF Power Output	50W