Yamaha DM2000 User Manual

Inserting Mix Parameters into Automix 203
DM2000 Version 2—Owner’s Manual
7 Start the timecode source.
The AUTOMIX [REC] button indicator lights up continuously, and on the Automix Main
and Memory pages, the REC and PLAY buttons appear highlighted.
8 Adjust the faders and other controls as necessary.
Use the SELECTED CHANNEL section to edit the currently selected channel. Channels are
selected automatically when the [AUTO] buttons are pressed. You can punch channels out
of recording by using the [AUTO] buttons.
9 To stop Automix recording, stop the timecode source or press the STOP but-
ton on the Automix Main or Memory page.
When the Mix Update Confirmation preference is on (see page 277), a confirmation mes-
sage appears asking if you want to update the existing Automix data (i.e., keep the edits just
recorded).
Inserting Mix Parameters into Automix
You can insert the static mix parameter settings into the range specified by the IN and OUT
parameters in the current Automix data. This is useful when you want to quickly insert
static EQ settings into a specified range of the Automix data.
1 Follow Steps 1–4 as described in the “Recording an Automix” section on the
previous page, then press the AUTOMIX [DISPLAY] button to display the
Automix Main page.
Time Time
IN OUT
Before Insert After Insert
Event No event Event
Inserted
parameter value
Event erased
Value prior to Insert

Yamaha DM2000 Specifications

General

Type	Digital Mixing Console
Channels	96
Sampling Rate	44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz
Bit Depth	24-bit
Aux Sends	12
Matrix	8 x 8
EQ Bands	4-band parametric
Word Clock	Yes
Effects	Internal Effects Processors
Digital I/O	AES/EBU, ADAT
Display	LCD