Effects Parameters 327
DM2000āOwnerās Manual
OCTA REVERB
Eight input, eight output reverb.
AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround. You can reset to the pan position speciļ¬ed by
the OFFSET parameter by pressing the RESET button.
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter Range Description
REV TIME 0.3ā99.0 s Reverb time
REV TYPE Hall, Room, Stage, Plate Reverb type
INI. DLY 0.0ā100.0 ms Initial delay before reverb begins
HI. RATIO 0.1ā1.0 High-frequency reverb time ratio
LO. RATIO 0.1ā2.4 Low-frequency reverb time ratio
DIFF. 0ā10 Reverb diffusion (leftāright reverb spread)
DENSITY 0ā100% Reverb density
E/R BAL. 0ā100%
Balance of early reļ¬ections and reverb
(0% = all reverb, 100% = all early reļ¬ections)
HPF THRU, 21.2 Hzā8.00 kHz High-pass ļ¬lter cutoff frequency
LPF 50.0 Hzā16.0 kHz, THRU Low-pass ļ¬lter cutoff frequency
Parameter Range Description
SOURCE
OFF, HOLD, INPUT1,
INPUT2, INPUT3,
INPUT4, INPUT5,
INPUT6, MIDI
When set to OFF, the TRIGGER button is used to start autopan.
When set to HOLD, autopan runs continuously. When set to INPUT
1ā6, the speciļ¬ed channelās input signal triggers autopan. When set
to MIDI, a MIDI Note On message can be used to trigger autopan.
TRIG. LVL ā60 to 0 dB
Input trigger level (i.e., the signal level required to trigger panning
when SOURCE set to INPUT)
TRG MASK 0ā1000 ms
Trigger Mask speciļ¬es the time from when a trigger is received until
the next trigger will be accepted.
TIME 0.0 sā10.0 s The time after which autopan starts once itās been triggered
SPEED 0.05 Hzā40.00 Hz Autopan speed
DIR. Turn L, Turn R Autopan direction
OFFSET ā180 to +180 degrees Pan offset
HPF THRU, 21.2 Hzā8.00 kHz High-pass ļ¬lter cutoff frequency
LPF 50.0 Hzā16.0 kHz, THRU Low-pass ļ¬lter cutoff frequency
Parameter Range Description
FREQ. 0.05ā40.00 Hz Modulation speed
AM DEPTH 0ā100% Amplitude modulation depth
PM DEPTH 0ā100% Pitch modulation depth
MOD. DLY 0.0ā400.0 ms Modulation delay time
WAVE Sine, Tri Modulation waveform
HPF THRU, 21.2 Hzā8.00 kHz High-pass ļ¬lter cutoff frequency
LPF 50.0 Hzā16.0 kHz, THRU Low-pass ļ¬lter cutoff frequency
SYNC OFF/ON Tempo parameter sync on/off
NOTE
1
1.
Used in conjunction with TEMPO to determine FREQ.