312 Appendix A: Parameter Lists
DM2000—Owner’s Manual
DELAY LCR
One input, two output 3-tap delay (left, center, right).
ECHO
Two input, two output stereo delay with crossed feedback loop.
Parameter
Range Description
DELAY L 0.0–2730.0 ms Left channel delay time
DELAY C 0.0–2730.0 ms Center channel delay time
DELAY R 0.0–2730.0 ms Right channel delay time
FB. DLY 0.0–2730.0 ms Feedback delay time
LEVEL L –100 to +100% Left channel delay level
LEVEL C –100 to +100% Center channel delay level
LEVEL R –100 to +100% Right channel delay level
FB. GAIN –99 to +99%
Feedback gain (plus values for normal-phase feedback, minus val-
ues for reverse-phase feedback)
HI. RATIO 0.1–1.0 High-frequency feedback ratio
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
SYNC OFF/ON Tempo parameter sync on/off
NOTE L
1
1. (Maximum value depends on the tempo
setting)
Used in conjunction with TEMPO to determine DELAY L
NOTE C
1
Used in conjunction with TEMPO to determine DELAY C
NOTE R
1
Used in conjunction with TEMPO to determine DELAY R
NOTE FB
1
Used in conjunction with TEMPO to determine FB. DLY
Parameter Range Description
DELAY L 0.0–1350.0 ms Left channel delay time
DELAY R 0.0–1350.0 ms Right channel delay time
FB.DLY L 0.0–1350.0 ms Left channel feedback delay time
FB.DLY R 0.0–1350.0 ms Right channel feedback delay time
FB. G L –99 to +99%
Left channel feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
FB. G R –99 to +99%
Right channel feedback gain (plus values for normal-phase feed-
back, minus values for reverse-phase feedback)
L->R FBG –99 to +99%
Left to right channel feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase feedback)
R->L FBG –99 to +99%
Right to left channel feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase feedback)
HI. RATIO 0.1–1.0 High-frequency feedback ratio
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
SYNC OFF/ON Tempo parameter sync on/off
NOTE L
1
1. (Maximum value depends on the tempo setting)
Used in conjunction with TEMPO to determine DELAY L
NOTE R
1
Used in conjunction with TEMPO to determine DELAY R
NOTE FBL
1
Used in conjunction with TEMPO to determine FB. D L
NOTE FBR
1
Used in conjunction with TEMPO to determine FB. D R
To Next Page
Loading...
