Yamaha DM2000 - Page 56

56 Chapter 3—Operating Basics
DM2000 Version 2—Owner’s Manual
Encoder Displays
Operation of the Encoder displays depends on the parameter assigned to the
Encoders, as follows.
Pan Mode, Surround L/R, and Surround F/R position
Aux/Mtrx Mode and Alt Layer
Surr LFE Level
Attenuator Parameter
Delay Feedback Gain, Delay Mix & EQ Gain Parameters
On/Off & Pre/Post Parameters
EQ On/Off, Phase On/Off, Insert On/Off, EQ Type, Gate On/Off, Comp On/Off, Aux Send
Pre/Post.
Scene Fade Time Parameters
Other position Hard rightCenter
( indicates at center)
Hard left
( indicates center position)
Other position MaximumNominal
( indicates at nominal)
Minimum (–∞)
( indicates nominal position)
Other position MaximumNominal
( indicates at nominal)
Minimum (–96 dB)
( indicates nominal position)
Other position MaximumNominal
( indicates at nominal)
Minimum (–96 dB)
( indicates nominal position)
Negative value
( indicates 0%, ±0 dB)
Positive value0%, ±0 dB
( indicates at 0%, ±0 dB)
On/Pre Off/Post
Minimum
(Off when Fade Time is minimum)
MaximumOther value