Yamaha WR250F 2021 - Page 167

HANDLEBAR
4-41
TIP
Apply the lithium-soap-based grease on the
throttle grip sliding surface.
11.Install:
• Throttle cable “1”
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handlebar.
12.Install:
• Throttle cable housing “1”
• Screw (throttle cable housing) “2”
WARNING
EWA19310
After tightening the throttle cable housing
screws, check that the throttle grip “3”
moves smoothly. If it does not, retighten the
screws for adjustment.
13.Install:
• Rubber cover “1”
• Cover (throttle cable housing) “2”
14.Install:
• Start switch “1”
• Front brake master cylinder assembly “2”
• Front brake master cylinder holder “3”
• Bolt (brake master cylinder holder) “4”
• Clamp “5”
TIP
• Install the brake master cylinder holder with the
“UP” mark facing up.
• Install in order for the top of the front brake
master cylinder assembly to be level.
• First, tighten the upper bolt, then the lower bolt.
Screw (throttle cable housing)
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
1
2
T
R
.
.
Front brake master cylinder hold-
er bolt
9 N·m (0.9 kgf·m, 6.6 lb·ft)
T
R
.
.