CABLE ROUTING DIAGRAM
2-24
1. Joint coupler
2. Plug cap
3. Cylinder head cover
4. Wire harness
5. Fuel hose
6. Starter motor lead
7. Holder
8. Ignition coil
9. Side core
10.Sub-lead wire
11.Sub-lead wire coupler
12.Air filter assembly
13.Fuel tank bracket
14.Grommet
15.ECU (Engine Control Unit)
16.Clamp
17.High tension cord
18.Fuel injector lead
19.Clamp (wire harness)
20.Throttle position sensor lead
21.Intake air pressure sensor lead
22.Diode
23.Intake air pressure sensor coupler
24.Air filter breather hose
25.Throttle body
26.Fuel injector coupler
27.Rectifier/regulator lead (wire harness)
A. Install the plug cap so that there is no gap
between it and the cylinder head cover.
B. Fasten the starter motor lead along the locat-
ing damper.
C. To the sub-lead wire.
D. Scratching between the fuel tank bracket and
tools when tightening the bolts is accepted.
E. Right side of the vehicle.
F. ± 1 0
G. Install the plug cap so that it faces to the right
side of the vehicle.
H. Install the collar with its flange facing to the
head of the bolt.
I. Insert the clamp into the rib so that it contacts
the rib.
J. It does not matter if the high tension cord and
grommet do not contact the ECU.
K. Pass the wire harness between the ECU and
air filter assembly.
L. Fasten the wire harness, clutch switch lead
and start switch lead by the clamp, and insert
the clamp projection into the hole in the sheet
metal of the radiator. The direction of the
clamp lock portion does not matter. It is
allowed to run the leads near the radiator cap
on the inside.
M. No pinch is allowed the leads between the
tank rail and the air filter joint.
N. Insert the projection of the wire harness into
the hole in the frame.
O. Route the air filter breather hose outside the
vehicle past the intake air pressure sensor
lead, and then route it above the vehicle
along the intake air pressure sensor coupler.
To Next Page
Loading...
