Physical Installation 1 - 16
Mounting the Digital Operator
Attach the front cover, mount the Digital Operator onto the Drive using the following procedure.
1. Hook the Digital Operator at A (two locations) on the front cover in the direction of arrow 1 as shown in the following
illustration.
2. Press the Digital Operator in the direction of arrow 2 until it snaps in place at B (two locations).
Fig 1.14 Mounting the Digital Operator
IMPORTANT
1. Do not remove or attach the Digital Operator or mount or remove the front cover using methods other
than those described above, otherwise damage to the Digital Operator or Drive may occur.
2. Never attach the front cover to the Drive with the Digital Operator attached to the front cover. Damage to
the Digital Operator will occur. Always attach the front cover to the Drive first, and then attach the Digital
Operator to the front cover.
A
B
To Next Page
Loading...
Need help?
General
