n110
Operator LED LCD 0 or 1 0 5.16.1
Connection Setting
Setting Description
Fault Detection 0 Disabled ** Operation continues
Selection 1 Enabled Operation stops
(Oper Detect
Flt)
n111
Local/Remote LED LCD 0 or 1 0 5.15.1
Changeover Setting
Setting Description
Fault Detection 0
Cycle Extern RUN**
Must open and re-apply
Selection external RUN command
(LOC/REM 1 Accept Extern RUN Will accept external RUN
Change) command
n112
Starting Point 0.0 to 6.0 6.0 (Hz)
For OL at Low
Frequency
(Low Frq OL2
Start)
n113
Continuous 25 to 100 50 (%)
Operation
Level at 0 Hz
(OL2 Level @
0 Hz)
n114
Square Root N U1-14= FI level x n114 x 100 0 to 99 0
Monitor Gain
(Sqr Root N
Gain)
n115
kVA Selection 00 to 35
See Note 3
Table
(Inverter kVA A3-1
Sel)
n116
CT/VT LED LCD
Selection Setting
Setting 0 or 1 0
Table
(CT/VT 0
CT Operation **
A3-1
Selection) 1 VT Operation
NOTES:
* ( ) values are parameter settings after a 3-Wire reset code has been entered.
** Factory setting for parameters with non-numerical data (n002, n004, etc.) is shown as bold followed by ** in “Description” column. Units shown in ( )
only appear with LCD display.
1. Initial value differs depending on V/f curve selected (
n010
setting). Values shown are initial values when
n010
is set to " 1 ".
2. To be accepted, the user setting must be between 10% and 120% of the drive’s output current rating. See Table A3-1 and paragraph 5.26.
3. Initial value depends on drive capacity – see Table A3-1.
4. Range and increment may change due to a “custom” setting of
n023
— see paragraph 5.8.
5. When a parameter number is enclosed in a shaded box that parameter can also be examined and set by means of a Quick-Start Display.
6.
n054
setting of “7.0 kHz” (“10”) is only available on GPD506V-B096 (CIMR-P5M40451F).
A1-15
10
Table A1-1. Drive Parameters (
nXXX
) – Continued
PARAM.
FUNCTION NAME SETTING FACTORY USER PARA.
NO. (ACTUAL DISPLAY)
DESCRIPTION
RANGE SETTING ** SETTING REF.
To Next Page
Loading...
