Standards Compliance
9
9.3 European Standards
YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup 295
9.3 European Standards
Figure 9.2 CE Mark
The CE Mark identifies that the product meets environmental and safety standards in the European Union. Products
manufactured, sold, or imported in the European Union must display the CE Mark.
European Union standards include standards for electrical appliances (Low Voltage Directive), standards for electrical
noise (EMC Directive), and standards for machinery (Machinery Directive).
This product displays the CE Mark in accordance with the Low Voltage Directive, the EMC Directive, and the
Machinery Directive.
Table 9.1 Harmonized Standard
European Directive Harmonized Standard
Low Voltage Directive
2014/35/EU
EN 61800-5-1:2007
EMC Directive
2014/30/EU
EN 61800-3:2004/A1:2012
First environment restricted distribution
Machinery Directive
2006/42/EC
• EN 61800-5-2:2007 (SIL3)
• EN 62061:2005/A2:2015 (SIL CL3)
• EN ISO 13849-1:2015 (PL e (Cat.Ⅲ))
The customer must display the CE Mark on the final device containing this product. Customers must verify that the
final device complies with EU standards.
◆ EU Declaration of Conformity
Go to www.yaskawa.com and search for "EU Declaration of Conformity" to get an original copy of the EU
Declaration of Conformity.
Yaskawa declares that this product complies with the following directives and standards at our sole responsibility.
◆ CE Low Voltage Directive Compliance
It has been confirmed that this product complies with the CE Low Voltage Directive by conducting a test according to
IEC/EN 61800-5-1:2007.
The following conditions must be satisfied for machines and devices incorporating this product to comply with the
CE Low Voltage Directive.
■ Area of Use
Install this product in a location with Overvoltage Category III and pollution degree 2 or less.
■ Guarding Against Debris
When you install IP20/UL Open Type drives (model: 2xxxxB, 4xxxxB), use an enclosure that does not let unwanted
material enter the drive from above or below.
◆ EMC Directive
Drives with built-in EMC filters were tested in accordance with European standard IEC/EN 61800-3:2004/A1:2012,
and comply with the EMC Directive.
To Next Page
Loading...
Need help?
General
