EasyManua.ls Logo

YASKAWA varispeed G7 CIMR-G7B series

YASKAWA varispeed G7 CIMR-G7B series
495 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Constant Tables
5-39
F1-05
PG rotation 0: Phase A leads with
Forward Run Command.
(Phase B leads with
Reverse Run Command.)
1: Phase B leads with
Forward Run Command.
(Phase A leads with
Reverse Run Command.)
0 or 1 0 No No A No A No 384H
6-158
PG 方向设定
F1-06
PG division
rate (PG
pulse moni-
tor)
Sets the division ratio for the
PG speed control board pulse
output.
Division ratio = (1+ n) /m
(n=0 or 1 m=1 to 32)
This constant is only effective
when a PG-B2 is used.
The possible division ratio
settings are: 1/32 F1-06 1.
1 to
132
1NoNoANoANo385H
6-159
PG 输出分频比
F1-07
Integral value
during accel/
decel enable/
disable
Sets integral control during
acceleration/deceleration to
either enabled or disabled.
0: Disabled (The integral
function isn't used while
accelerating or
decelerating; it is used at
constant speeds.)
1: Enabled (The integral
function is used at all
times.)
0 or 1 0 No No A No No No 386H
6-159
积分动作选择
F1-08
Overspeed
detection
level
Sets the overspeed detection
method.
Frequencies above that set for
F1-08 (set as a percentage of
the maximum output fre-
quency) that continue to
exceed this frequency for the
time set in F1-09 are detected
as overspeed faults.
0 to
120
115% No No A No A A 387H
6-159
过速检出值
F1-09
Overspeed
detection
delay time
0.0 to
2.0
0.0 s
*
No No A No A A 388H
6-159
OS 过速检出
时间
F1-10
Excessive
speed devia-
tion detec-
tion level
Sets the speed deviation
detection method.
Any speed deviation above
the F1-10 set level (set as a
percentage of the maximum
output frequency) that contin-
ues for the time set in F1-11 is
detected as a speed deviation.
Speed deviation is the differ-
ence between actual motor
speed and the reference com-
mand speed.
0 to 50 10% No No A No A A 389H
6-159
DEV 检出值
l
F1-11
Excessive
speed devia-
tion detec-
tion delay
time
0.0 to
10.0
0.5 s No No A No A A 38AH
6-159
DEV 检出时间
Con-
stant
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
MEMO-
BUS
Regis-
ter
Page
Display
V/f
V/f
with
PG
Open
Loop
Vec-
tor
1
Flux
Vec-
tor
Open
Loop
Vec-
tor
2
F1-06
nm

Table of Contents

Related product manuals