Yealink T22P Guide

Enterprise IP Phone Using the Basic Call Functions
- 8 -
actions.
Audio Device Control Keys
Use the audio device control keys to perform the following actions depending on your
phone type:
： Adjust the volume of the handset, headset, speaker and ring tone;
： Allows for hands-free communication during calls;
Press to switch to the Group Listening mode.
： Place and receive calls through an optionally connected headset.
： Mute audio transmission locally during calls;
Hard Feature Keys
： Allow users to access the Voice Mail interface directly;
： Forward the current call to third party;
When the phone is idle, press to enter the forward configuration page.
： Press to enter the Dialed Calls interface, then choose a record to dial out.
LED Instruction
Table 1 Line Keys
LED Status
Description
Steady green
The account is active
Blinking green
There is an incoming call to the account, or there is a call on hold
status
off
The phone is in idle status whatever registered/ unregistered

Yealink T22P Specifications

General

Protocol	SIP
Power over Ethernet	Yes (IEEE 802.3af)
Weight	0.77kg
Audio Features	Full-duplex speakerphone
Lines	3
Codecs	G.722, G.711
Standards Compliance	IEEE802.3af
Dimensions	209mm x 188mm x 150mm x 41mm
Headset Port	RJ9