Enterprise IP Phone Using the Advanced Phone Functions
Using the Advanced Phone Functions
Account Setting
Please refer to the previous part “Configuration and Registration” for the basic Account
setting information. The following table lists the instruction of the field about the
advanced Account Setting.
Defines whether to active the phone UDP Keep-alive
mechanism. The default is Enabled.
UDP Keep-alive
Interval(seconds)
This parameter specifies how often the phone will send a packet
to the SIP server. Default is 30 seconds.
This parameter specifies the time frequency that phone
refreshes its registration. The default interval is 3600 seconds.
Local SIP port. The default value is 5060.
Defines the local RTP port that the phone will listen and
transmit. The default value is 11780.
The parameter allows you configuring the proxy to send
responses back to a particular address and port. The default is
disabled.
This document defines an extension to the Session Initiation
Protocol (SIP). This extension allows for a periodic refresh of
SIP sessions through a re-INVITE or UPDATE request. The
refresh allows both user agents and proxies to determine if the
SIP session is still active.
Subscribe
Period(seconds)
This parameter could set the period of the subscription. The
default value is 3600.
You can only configure these settings via Web interface.
1) Choose Account.
2) Select the desired account.
3) Choose Advanced interface to do the relating settings.
You can consult your system administrator for more information.
To Next Page
Loading...
Need help?
General
