Yealink VC110 - Page 30

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
14
effectively pick up sounds.
Turning On or Off the VCM60
There is a power switch on the bottom of the VCM60. Turn on the power switch to start the
VCM60. After the VCM60 starts, it registers with the paired dongle automatically. You can turn
off this switch if the VCM60 is not in use for a long period of time.
Connecting VCM60 to the Video Conferencing Endpoint
To ensure good voice quality, VCM60 video conferencing wireless microphone can be
connected to the VC110 video conferencing endpoint to work as the audio input device.
To connect the VCM60 to the VC110 video conferencing endpoint, do the following:
1. Connect the dongle to one of the USB ports on the VC110 all-in-one unit.