Yealink VC800 - Placing Calls

Using the VC800 Video Conferencing System
93
3. Select Auto from the pull-down list of Call Type before calling.
4. On system A, dial the account numbers of system B.
Result：
 If account polling is disabled, system A can only use its Cloud account (highest priority) to
call system B.
 If account polling is enabled, system A will use its Cloud account (highest priority) to call
system B first. If this call fails, system A continues to use its SIP account (next priority) to
call system B.
Placing Calls
You can place a call in three ways using your VC800 video conferencing system:
 Using the remote control
 Using the CP960 conference phone
 Via web user interface
The VC800 video conferencing system supports two call modes:
 Voice Call
 Video Call
Note
You can search and dial a contact from the call history or local directory. For more information,
The system supports placing calls using contact numbers, SIP URI, IP address, H. 323 account or
extension. SIP URI and IP addresses can be up to 32 characters. For example: SIP
URI:2210@sip.com, IP: 192.168.1.15.
For more information, contact your system administrator.