User Guide for the VC800 Video Conferencing System
132
Specifying Content to the secondary display device
To specify the content to be displayed on the secondary display device via the remote
control:
1. Press or to open Talk Menu.
2. Press or to scroll to Other, and then press to expand the menu.
3. Press or to scroll to Focus (Display2) and then press to enter submenu.
4. Press or to scroll to select the desired content, and then press .
The secondary display device displays the selected content. The icon is displayed on
the focus content.
After reassigning the content, the PC content on the second display device will
automatically be displayed on the primary display device.
Voice Activation
Voice activation displays the active speaker in largest pane. Other participants are displayed in a
strip beside the active speaker. To minimize the changes in the layout, when a new speaker is
identified, the previous speaker is replaced by the new speaker. You can configure voice
activation via web user interface only.
To configure the voice activation via web user interface:
1. Click on Setting->Conference Setting.
2. Select the desired value from the pull-down list of Voice Activation.
3. Select the desired value from the pull-down list of Video Hold Active Duration.
When a participant’s voice duration is greater than this duration (1 second), the system
refreshes the display and replaces the last active speaker with the active speaker.
To Next Page
Loading...
