Yealink VC800 - Getting Started; Connecting the VC800 Video Conferencing System

Getting Started
21
Getting Started
This chapter provides the following basic installation instructions and information for achieving
the best performance from your VC800 video conferencing system. Topics include:
 Connecting the VC800 Video Conferencing System
 Installing the VC800 Video Conferencing System
 Installing Batteries for the Remote Control
 Powering the System On
 Put the System to Sleep
 Powering the System Off
 Setup Wizard
 Controlling Local Camera
 Registration
 Idle Screen
 Navigating Menus and Fields
 Entering Data and Editing Fields
 System Status
If you require additional information, or assistance to help you use your new phone, contact
your system administrator.
Connecting the VC800 Video Conferencing System
This section introduces the following:
 Connecting the VC800 codec
 Connecting the Audio Device
Note
Up to two display devices can be connected to the VC800 codec. Because the display device is
not included in the package, you need to purchase it separately if required. Ensure that the
purchased display device supports HDMI input.
When connecting only one display device to the VC800 codec, display1 port is the only available
port. If dual screen mode is required, you can connect secondary display device to the Display2
port.
To prevent shock, do not connect the power adapter and turn on the power before connecting
all system components.