YOKOGAWA DL850E User Manual

2-1
IM DL850E-03EN
Main Features
1
2
3
4
5
6
App
Index
2.1 Vertical and Horizontal Axes
Vertical Axis
This section explains how to configure the signal input settings and the amplitude-direction display
settings. The items that can be set vary depending on the installed modules. The channel menu that
corresponds to the key you pressed (CH1 to CH16) appears. You can set the various vertical axis
settings for each channel. Press ALL CH to display a screen in which you can configure the settings of
all channels while viewing the settings in a list.
DL850E/DL850EV Measurement Items
When the DL850E/DL850EV is equipped with the modules listed below, it can measure voltage,
temperature, strain, acceleration, frequency, logic, CAN bus signals, LIN bus signals, SENT signals,
and so on.
Voltage
701250 (HS10M12), 701251 (HS1M16), 701255 (NONISO_10M12), 701267 (HV (with RMS)),
720210 (HS100M12), 720211 (HS100M12), 701261 (UNIVERSAL), 701262 (UNIVERSAL (AAF)),
701265 (TEMP/HPV), 701275 (ACCL/VOLT), 720254 (4CH 1M16)
Voltage (For the 16-CH Voltage Input Module)
720220 (16CH VOLT)
Temperature
701261 (UNIVERSAL), 701262 (UNIVERSAL (AAF)), 701265 (TEMP/HPV)
Temperature (For the 16-CH Temperature/Voltage Input Module)
720221 (16CH TEMP/VOLT)
Strain
701270 (STRAIN_NDIS), 701271 (STRAIN_DSUB)
Acceleration
701275 (ACCL/VOLT)
Frequency
701281 (FREQ)
Logic
720230 (LOGIC)
CAN Bus Signal Monitoring
720240 (CAN MONITOR), 720241(CAN & LIN)
This module can only be used with the DL850EV.
LIN Bus Signal Monitoring
720241 (CAN & LIN)
This module can only be used with the DL850EV.
SENT Signal Monitoring
720243 (SENT)
This module can only be used with the DL850EV.
Chapter 2 Main Features

YOKOGAWA DL850E Specifications

General

Brand	YOKOGAWA
Model	DL850E
Category	Test Equipment
Language	English